6 Fixes for Linksys Velop Node Not Connecting Issue
A Linksys Velop WiFi system consists of different nodes. These nodes help to eliminate WiFi dead spots and hence can be placed in areas like garages, basements, etc where you need to have internet access. If your Linksys Velop node not connecting to the primary node, then you need to try some possible troubleshooting hacks that have been discussed in this guide. There can be many reasons for this problem. The excessive distance between the nodes and poor internet connection are the two most common ones. We have tried to cover every possible reason and provided their solutions here. Hence go on reading without skipping any points in between.
Let’s Fix Linksys Velop Node Not Connecting Issue
Fix 1: Bring Node Closer to the Primary Node
When you are trying to connect the Linksys child node to the primary node, it is essential that both nodes are placed closer to each other such that it is easy for them to communicate. If you have committed the mistake of placing the nodes much apart, then you know why you are facing the Linksys Velop node not connecting issue.
We suggest you bring the nodes closer to each other. Let the devices connect and then you can move the child node to a new location. But even after that, you must make sure that the child node is placed within the network range of the primary node.
Fix 2: Use a Wired Connection
The Linksys nodes can be connected wirelessly. At times, wireless connection does not happen in an easy manner. In such a case, you can use an Ethernet cable to connect the two devices. Wired connections are much more reliable than wireless connections. There are fewer chances of disconnections. Hence grab an Ethernet cable and make a firm connection between the two nodes.
Fix 3: Update Firmware
One reason why the nodes are not getting connected is that the firmware on the Linksys devices is not updated. You can fix this issue simply by updating the firmware to the latest version. To upgrade your device, access the Linksys router login page and reach its settings. From here, you can install the most recent firmware version on your Linksys nodes. As soon as the firmware gets updated, try to connect the Linksys child node to the primary node.
Fix 4: Insect the Wiring
When the connection between the devices is not stable due to faulty cables, then also you may face similar issues like the Linksys node not connecting to the main node. You should therefore consider examining the cables connected to the devices. See to it that the connection between the primary node and the modem is stable and the cable in use is not damaged. Also if the primary node and the child node are connected using a cable, this also should be damage free and tightly connected into the right ports.
Fix 5: Reboot Linksys Velop Nodes
A prominent cause that stops the devices from getting connected is a software glitch. The reason for the glitches is not specific. You can try fixing them by starting the Linksys devices. So, power off the Linksys nodes and remove the cables connected to them. After letting the devices sit idle for some time, connect them again and power them up. This should help in connecting the devices without any trouble.
Fix 6: Reset the Node
Resetting should be considered as the final hack. After you have tried all other fixes and failed to get the problem resolved, then reset your Linksys node. The node should be running on the factory settings if you are trying to connect it for the first time. So, reset your node and restore the default settings on it.
After you have reset your Linksys node, you can easily connect it to the primary node. We are very hopeful that the Linksys Velop node not connecting issue would have bid you goodbye by now. You can now get various devices connected to the secondary node network and begin enjoying it.