Linksys Router Red Light Issue [Reasons and Solutions]
Considering you are here, we are not backing away from thinking that you are out of the many victims of the Linksys router red light issue. It might be because of the reasons mentioned as you read this blog post further:
1st Reason: The wall socket to which the Linksys wireless router is connected is damaged or a power outage happened in the area that affected its performance.
2nd Reason: The Linksys router and the existing modem do not have a stable connection between them. This could be due to the usage of a damaged Ethernet cable.
3rd Reason: In a time when updating the firmware of your Linksys router was important, you ignored it thereby interrupting the scope of any improvement.
Read the solutions mentioned in the next section of this blog post and learn how you can resolve the Linksys router red light issue in a hassle-free manner.
Linksys Router Red Light Issue [The Ultimate Fixes]
1st Solution: Call Up an Electrician
The first thing that must be done from your end is to check the wall socket that has been assigned the duty of providing electricity to your networking device, i.e. the Linksys wireless router. In case it is damaged or short-circuited for that matter, then it is recommended that you call an electrician at your home.
Although he will be able to fix the outlet, in case he fails to, then you can opt for another one. Make sure that the other wall outlet is not damaged like the previous one. Otherwise, the LED light on your Linksys wireless router will continue to blink red and might not ever turn green. Thus, take this advice very seriously.
2nd Solution: Use a Brand New Cable
Another reason, as mentioned in the introduction of this blog behind the Linksys router red light issue is the usage of a damaged Ethernet cable. To take care of the problem, taping up the cable using a cello tape might help. In case this does not, then you can purchase a new one in order to establish a connection between the networking devices.
For your information, the Ethernet cable is also called the RJ-45 cable. So, whenever you go to purchase it, do not get confused if the seller asks you whether you need a RJ-45 cable. It means the same thing. Now, check again in case the Linksys router red light issue has left following you around. In case, it persists, then you can continue reading.
3rd Solution: Update the Firmware
The last attempt that you can make to resolve the issue in discussion is to update the firmware of the networking device. Two processes can be used for this. One requires you to make use of a computer whereas the other mobile device. However, one thing is common between them, i.e. the usage of the Linksys router logincredentials.
By any chance, if you are not certain about how this process can be gone about, then you can either read the instructions given on the official website of Linksys wireless router or the ones in the user manual of your networking device. Starting from the processes to the various features, you will find each and everything related to your router there.
This ends the guide discussing the various solutions through which the Linksys router red light issue can be put to an end. On the off chance, it is still not getting off the hook, and then you can try to reset the networking device. For this, follow these steps:
- Locate the reset hole on the router.
- It might either be located at the bottom of the device or one of the corners.
- Press the button inside it whenever you find it and wait for some time.
- To be specific, give more than five minutes to your device.
- Make sure that you are only using an oil pin or a paper clip for this.
- The usage of the tip of a pen will only cause issues for you.
We are saying this because,as said before, inside the reset hole, there is a tiny button located. It can only be pressed with an object that is thin thereby, the reason why we suggested the use of an oil pin or a paper clip. Once you have reset the device, let it reboot.
Has it finished rebooting? Good. Now, you may configure it right from scratch with the aid of the default web address, admin login credentials, an updated browser, and a stable connection to the computer as well as the modem.